Skip to main content

Pulsecounter Nodes

Use these nodes to count pulse received on a gpio pin.

Config Nodes

pulse counter init

Configure the pulse counter and set the pulse counter to ready mode.

Inputs

  • Signal Input Pin no. : Specify the signal input pin number
  • Control Pin Enable : Whether control pin is enabled or not
  • Control Input Pin no. : Specify the control input pin number
  • Unit no. : Select the unit number
  • Channel no. : Select the pulse counter channel
  • Positive edge mode. : Select the type of positive mode for the pulse counter
  • Negative edge mode. : Select the type of negative mode for the pulse counter
  • High control mode. : Select the high control mode for the pulse counter
  • Low control mode. : Select the low control mode for the pulse counter
  • Maximum value. : Specify the maximum counter value limit
  • Minimum Value. : Specify the minimum counter value limit

Proc Nodes

pulse counter start

Pulse Counter starts counting the signals of the pulses.

Inputs

  • Pulse counter Config : Select the pulse counter config

pulse counter stop

Pulse Counter stops counting the signals of the pulses.

Inputs

  • Pulse counter Config : Select the pulse counter config

pulse counter reset

Pulse Counter clears and reset the value of the pulse count.

Inputs

  • Pulse counter Config : Select the pulse counter config

get pulse count value

Gets the Pulse Count value from the pulse counter.

Inputs

  • Pulse counter Config : Select the pulse counter config

Outputs

  • Pulse Count : Pulse Counts

Event Nodes

on pulse count event

An Event Producer Node. Triggers when the pulse counter event occurs.

Inputs

  • Pulse counter Config : Select the pulse counter config
  • Threshold1 Event (2) : Whether to enable threshold1 crossed event
  • Threshold1 Value. : Specify the threshold1 value
  • Threshold0 Event (3) : Whether to enable threshold0 crossed event
  • Threshold0 Value. : Specify the threshold0 value
  • Low Count Event (4) : Whether to enable low count event
  • High Count Event (5) : Whether to enable high count event
  • Zero Count Event (6) : whether to enable zero count event

Outputs

  • Triggered Event : triggered event type